To which net I configure as my interesting packet because both net of my
remote site LAN is also on sub interfaces of my Central site Fast Ethernet
Interface. I can't define route to a net which is also on my directly
connected interface.
>>
>>Don't look for an interface going down, instead configure a floating
default
route as your interesting packet.
Dave
Khurrum Shahzad wrote:
Hi all
I want help regarding my scenario which is as follows.
I have one central and tow remote sites. Both two remote sites are
connected
with central through Wireless Ethernet Bridge (high speed).
At Central site Ethernet cable from both Wireless Bridge are connected to
switch and Cisco 2620 is used for routing between 3 different VLAN ( two
for
remote and one for central).
So at central site I have 3 sub interface on Fast Ethernet each having IP
address of separate net.
I also require Sync Dial Backup for each remote site. So I placed one 1601
and Sync dialup modem on each remote site and dialup modems at central
connected with sync port of 2620.
But I can't understand how to configure online (automatic) backup because
if
any of wireless link will break or down, Ethernet ports will not down and
dialer will not initiate.
Also for manual backup, if I manually dial to central site from any remote
site then after connected to central, I have same IP net on both site of
link,
it means Ethernet port of 1601 and fast Ethernet port of 2620 have Ethernet
IP
from same net.
Can anybody guide me how I run my main links on Wireless Ethernet Bridge
and
backup link on dialup with routers?
Network diagram of my setup is at
http://www.geocities.com/khurrums/
Regards
Khurrum
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20100&t=20058
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
