Probably not a lot. You need to have inside and outside interfaces so
the router knows when to translate packets.
Check the NAT section here...
http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_c/1cprt2/1cipadr.htm
Follow those instructions there and you can't go wrong ;)
Cheers
Charlie
--- Ramesh c wrote: > Hey gurus,
>
> I am using NAT in my setup and I find only these entires related to
> NAT...what is really happening here?
>
> interface Ethernet0/0
> ip address 10.1.1.1 255.255.255.255
> ip nat inside
>
> interface serial0
> ip address xxx.xxxx.xxxx.xxxx(Connected to Internet)
>
> Anyone can help?
>
>
>
>
>
>
> Make a difference, help support the relief efforts in the U.S.
> http://clubs.lycos.com/live/events/september11.asp
[EMAIL PROTECTED]
____________________________________________________________
Do You Yahoo!?
Get your free @yahoo.co.uk address at http://mail.yahoo.co.uk
or your free @yahoo.ie address at http://mail.yahoo.ie
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=20881&t=20880
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
