Sorry but i was wrong, after a verification : I think that :
Question 2 is not A because, in case of RSM, you don't need to put the "set mls include" command. It's automatic and MLS is by default enable on CATALYST that support it. So I think the answer is B. Sorry for the confusion ... Regards, -- Stephane LITKOWSKI Student in a french computer science school EPITA Telecom & Network specialization CISCO Certified Network Associate EMail : [EMAIL PROTECTED] ""Stephane LITKOWSKI"" a icrit dans le message news: [EMAIL PROTECTED] > Question 1 > > I think the answer is : "show run" > > Question 2 > > I think the answer is A : > set mls enable > set mls include > > Question 3 > > the answers are B & D > > because : A is false command, good command is : set spantree portfast enable > and the priority doesn't influence the convergence time > > Hope it helps > > Regards, > > -- > Stephane LITKOWSKI > Student in a french computer science school > EPITA Telecom & Network specialization > CISCO Certified Network Associate > EMail : [EMAIL PROTECTED] > > > ""hoi fung chan"" a icrit dans le message news: > [EMAIL PROTECTED] > > Anyone can help me to answer this 3 question?? > > > > 1.Which command can you use to verify that a router interface has been > > configured for CGMP? > > a.show interface > > b.show run > > c.show pip > > d.show cgmp > > > > ** i think the answer should be "a", pls cfm!! > > > > 2.Which command(s) are required to configure the MLS-SE to participate in > > multiplayer switching with an RSM? > > > > a.set mls enable and set mls include rsm ip address commands in privilege > > mode > > b.No commands are required. MLS is enabled by default > > c.set mls include command in privileged mode > > d.set mls enable and set mls agingtime number of seconds commands in > > privileged mode > > e.set mls enable and set mls vtp-domain vtp domain name commands in > > privileged mode > > > > > > 3.Which command do you use to improve spanning-tree convergence? > > > > a.set spantree portfast > > b.set spantree backboneFast > > c.set spantree priority > > d.set spantree uplinkfast enable > > > > ** i think the answer should be "c", pls cfm!! Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=21867&t=21836 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
