First of all I am using it to console in to the phone switch not a modem. Second how would I set the speed to 2400. Access server has its own line speed different from baud rate. Like for expample 9600 would be equal to 38400 on access server? I found that on Cisco's web site.
Thanks, Alex Andy Hoang wrote: > If it says open then it works. Can you issue some modem commands? Try > ATZ. The modem should respond with an OK. You can set the access > server run at speed 2400. Is your cable correct? The modem is DCE and your > access server async line is DTE. > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of > khramov > Sent: Wednesday, October 03, 2001 2:50 PM > To: [EMAIL PROTECTED] > Subject: Re: Access Server config [7:21877] > > Nope there are no passwords, > I've got it to the point where I telnet into async 1 port and it opens it > up, but > nothing comes on the screesn, It just says open. I think there might be a > speed > mismatch issue, device that is attached to it runs at 2400 and I do no think > that you > can set access server to run at the speed lower then 9600. So if anyone has > any ideas > please help. > Here is the config: > interface Ethernet0 > ip address 192.168.190.25 255.255.255.0 > no ip route-cache > no ip mroute-cache > ! > interface Serial0 > no ip address > no ip route-cache > no ip mroute-cache > shutdown > ! > interface Serial1 > no ip address > no ip route-cache > no ip mroute-cache > shutdown > ! > interface Async1 > no ip address > async mode dedicated > no peer default ip address > ! > ip default-gateway 192.168.190.2 > no ip classless > ip route 0.0.0.0 0.0.0.0 192.168.190.2 > ip route 192.168.78.0 255.255.255.0 192.168.190.2 > ! > line con 0 > line 1 8 > no exec > modem InOut > transport preferred telnet > transport input all > stopbits 1 > speed 38400 > line 9 16 > line aux 0 > > Tarak Robbana wrote: > > > Is there a password set on the device your telneting into? Sorry, > > have to start with the small stuff. > > [GroupStudy.com removed an attachment of type text/x-vcard which had a name > of khramov.vcf] > _________________________________________________________ > Do You Yahoo!? > Get your free @yahoo.com address at http://mail.yahoo.com [GroupStudy.com removed an attachment of type text/x-vcard which had a name of khramov.vcf] Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=22032&t=21877 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
