What model is this showing up under? I am sure definitely not for the
2500 series??
RTF(config-if)#ip addr ?
A.B.C.D IP address
RTF(config-if)#ip addr dhcp
^
% Invalid input detected at '^' marker.
>From: "Glenn Johnson" >Reply-To: "Glenn Johnson" >To:
[EMAIL PROTECTED] >Subject: RE: ip dhcp-server under e0?? [7:22250]
>Date: Fri, 5 Oct 2001 15:59:36 -0400 > >Looks like a simple syntax issue
--- > >Serendipity(config-if)#ip add ? > A.B.C.D IP address > dhcp IP
Address negotiated via DHCP > >Serendipity#sh ver >Cisco Internetwork
Operating System Software >IOS (tm) 2500 Software (C2500-IS-L), Version
12.1(5)T5, RELEASE SOFTWARE >(fc1) > > >-----Original Message----- >From:
[EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of >Cisco
Nuts >Sent: Friday, October 05, 2001 3:01 PM >To: [EMAIL PROTECTED]
>Subject: ip dhcp-server under e0?? [7:22250] > > >Hello, >A couple of
weeks back someone had successfully configured his 2514 router >to get a
dhcp ip addr. from his cable service provider, configured nat on >the
router for his laptop to go out on the internet. I tried to do the same
>on my 2514 but I cannot type the command under e0 for my router to get
the >dhcp ip addr. from the service provider. I initially thought that it
was the >ios ver. (was using 11.3.(3)) I upgraded to 12.0.(9) but it
still will not >let me type the command. Will this command only work on
higher routers like >the 2600 and the 3600 series. Please advise. >Thank
you. >Kind regards. > >Output from the router: > >RTA(config-if)#ip dhcp
? >% Unrecognized command > > >RTA#conf t >Enter configuration commands,
one per line. End with CNTL/Z. >RTA(config)#int e0 >RTA(config-if)#ip ?
>Interface IP configuration subcommands: > access-group Specify access
control for packets > accounting Enable IP accounting on this interface >
address Set the IP address of an interface > authentication
authentication subcommands > bandwidth-percent Set EIGRP bandwidth limit
> broadcast-address Set the broadcast address of an interface > cgmp
Enable/disable CGMP > directed-broadcast Enable forwarding of directed
broadcasts > dvmrp DVMRP interface commands > hello-interval Configures
IP-EIGRP hello interval > > > >
>_________________________________________________________________ >Get
your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp >
misconduct and Nondisclosure violations to [EMAIL PROTECTED]
------------------------------------------------------------------------
Get your FREE download of MSN Explorer at http://explorer.msn.com
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=22285&t=22250
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
