Have discovered some packet loss on our network and figured it out to a duplex setting mismatch between two FE ports on Catalyst 5500 and a 7206.
The 5500 is set to auto mode for both the duplex and speed. The speed is ok but it autoed to half instead of full. When I try to put the port in full duplex I get this: Cisco 5500> (enable) set port duplex 10/11 full Port 10/11 is in auto-sensing mode. The port is in use obviously. How to pull this FE port from auto into manual settings? Ive looked the set port commands but none seem to relate to autosensing. Thanks, Keith Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24375&t=24375 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
