Hi everyone I'm trying to setup a ACS server for fault tolerance/load balancing (I'm not sure if they are separate features or work together) connected to two Cat 6Ks. The ACS is a HP netserver and was already set up with two NICs and a virtual interface before I got my hands on it. The nics are connected to separate switches each in the same vlan, with a trunk between the switches. When I plug the two interfaces into the switch only one of the interfaces actually works, any frames sent to the other nic are lost I presume. I've had a look on the CCO, m'soft and HPs site but I can't see much relevant info, can any provide some info or experience on this
Cheers Pat Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24494&t=24494 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
