Mike, I GOT IT TO WORK.... DLSW using frame in direct encapsulation,no ip addresses or routes in sight!!!
Thanks for all your suggestions. I didn't use the local dlci but did change the llc2 mappings to point to the dlci closest to the frame switch for each spoke router. So if rtr1 is spoke and its local dlci is 201 and the switch dlci for rtr1 is 102 then i used: rtr1 ! dlsw local-peer dlsw remote-peer 0 frame-relay interface Serial0/0 201 dlsw bridge-group 1 ! interface Serial0/0 no ip address encapsulation frame-relay clockrate 2000000 frame-relay map llc2 201 ! interface FastEthernet0/0 no ip address duplex auto speed auto bridge-group 1 and the same thing the other end. many thanks again for helping me. Just hope its a question in Brussels in March.... Cheers Richard Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24930&t=24930 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
