Nurul;
I've verified the process you been given, and it appears to be correct.
Keep in mind this is only going to reset the box to a null password for the
Manager account.
You still need to log in as Manager (Capital M) after the reboot.
For more info go to the support site and search under documentation for an
ARN Manual
http://www.nortelnetworks.com/servsup
"Nuurul Basar Mohd Baki" wrote in message
...
>Hai,
>
>I have a similar problem with Bay Advance Remote Node (ARN). I need to do a
>password recovery on it
>This is the suggestion given by Nortel tech support
>> ARN password removal
>> Fact: ARN
>> Symptom: If a customer has forgotten his Manager password for the ARN
>> Fix: Do the following steps:
>>
>> 1.Power Cycle the ARN
>>
>> 2.When the ARN starts cycling through Power on Diags, type Cntl-C
followed
>> by a carriage return.
>> This will put you in diagnostics mode and you will see the following
>> prompt: diag_1>>
>>
>> 3. At the prompt, type in the following command exactly as is:
>>
>> d/l/n:5 410000 0
>> This sequence will blank out the Manager password in NVRAM
>>
>> 4.Type boot or power cycle the ARN
>>
>I have try it but it wont works, I got 18 ARN to do password recovery
>
>Any help is appriactet
>
>
>Nuurul Basar Bin Mohd Baki
>Senior Customer Engineer
>Technical Support Department
>Solsis (M) Sdn Bhd
>Suite 5.02 Wisma Academy
>No 4A Jalan 19/1
>46300 Petaling Jaya
>Tel 603-79577300
>Fax 603-79562324
>
>
>> ----------
>> From: VoIP Guy[SMTP:[EMAIL PROTECTED]]
>> Reply To: VoIP Guy
>> Sent: Friday, November 16, 2001 7:56 PM
>> To: [EMAIL PROTECTED]
>> Subject: Re: Off Topic - Baystack 350T [7:26431]
>>
>> Use Xon/Xoff
>> 8,n,1
>>
>> The just hit enter, or ctr;+R.
>>
>>
>> ""Carroll Kong"" wrote in message
>> [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
>> > At 09:47 PM 11/15/01 -0500, Mark Rose wrote:
>> > >I was given a Baystack 350t and I'm trying to get into it to set up
the
>> > >configuration. I am using the default settings (9600,8,1,no,1,none). I
>> am
>> > >entering ctrl+C as per documentation. I get no response. I could use
>> > >suggestions from anyone who has used this switch.
>> > >
>> > >TIA
>> > >Mark
>> > Try ctrl-d, enter, etc. If it does not work, it might just be a bad
>> > one. I did an audit with a pile of these darn bay stacks, and some of
>> them
>> > would just REFUSE to work. Of course, since we audited so many of
them,
>> > 80% of them were consoleable, the others failed. Ah well.
>> >
>> >
>> >
>> > -Carroll Kong
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=26669&t=26431
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
