Hi All, I have two OSPF problems to resolve, hopefully you can help.
Question 1. =========== Problem is when redistributing from OSPF to IGRP. I have 3 routers say A, B, C. All subnets from 10.x.x.x. A----B----C A runs IGRP (all ints have 10.x.x.0/24 subnets) B runs IGRP and OSPF (with redistribution both ways) C runs OSPF (ints have various masks on 10.x.x.0 ie. /24's, /26's etc) Redistribution from IGRP to OSPF is fine, problem is going the other way. The non /24's from Router C are not in Router A's table. This is due to the IGRP domain only "using" /24 and hence the non /24's are never advertised out from B to A. If I was using EIGRP in place of OSPF, I just use a summary on B etc, to make the the non/24's look like /24's and out they go into IGRP. How do we do that for OSPF to IGRP?????. We can't use statics etc. Question 2. =========== How do I change the OSPF "dead interval" for two neigbours without using the ip ospf dead-interval command?. R3#sho ip ospf int s 0 Serial0 is up, line protocol is up Internet Address 10.1.1.1/28, Area 0 Process ID 100, Router ID 10.10.10.10, Network Type NON_BROADCAST, Cost: 64 Transmit Delay is 1 sec, State DROTHER, Priority 0 Designated Router (ID) 10.20.20.20, Interface address 10.1.1.1 No backup designated router on this network Timer intervals configured, Hello 30, Dead 120, Wait 120, Retransmit 5 <--------I want to change Dead time Hello due in 00:00:09 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 10.20.20.20 (Designated Router) Suppress hello for 0 neighbor(s) Message digest authentication enabled Youngest key id is 10 I can use the "poll-interval" key word on the neighbour command, but that is not the dead timer that you see in a show ip ospf nei, it is for after the neighbour is already down. R3#sho ip ospf nei detail Neighbor 10.20.20.20, interface address 10.1.1.1 In the area 0 via interface Serial0 Neighbor priority is 1, State is FULL, 7 state changes DR is 10.1.1.1 BDR is 0.0.0.0 Poll interval 200 <---------------I can change this via neighbour statement Options 66 Dead timer due in 00:01:57 What do you think?. Thanks, Paul. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=27424&t=27424 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
