When configuring BGP on a "singlehome" net, everything I read says the basic
config commands are ... for S 0\0 to S 0\0 (200.200.1.1 to 200.200.1.2)
wire 200.200.1.0
Router-A(config)#router bgp [as#]
Router-A(config-router)#network [subnet#]
Router-A(config-router)#neighbor [subnet#] remote-as [as#]
now filling in the blanks
Router-A(config)#router bgp [200]
Router-A(config-router)#network [200.200.1.0]
Router-A(config-router)#neighbor [200.200.1.1] remote-as [100]
unless I configure RIP on the same wire I get nothing. No mention of RIP in
any
of the books I reference. I config RIP and get a "from show ip route" this
C 200.200.1.0/24 is directly connected, Serial1
R 200.200.100.0/24 [120/1] via 200.200.1.1, 00:00:14, Serial1
[120/1] via 200.200.2.1, 00:00:14, Serial0
C 200.200.2.0/24 is directly connected, Serial0
C 192.168.1.0/24 is directly connected, Ethernet0
O 192.168.2.0/24 [110/74] via 192.168.1.2, 01:54:20, Ethernet0
O E2 192.168.3.0/24 [110/20] via 192.168.1.2, 01:54:20, Ethernet0
Not showing bgp on the connections
the Show ip bgp yields .....
Router-A#show ip bgp
BGP table version is 3, local router ID is 200.200.2.2
Status codes: s suppressed, d damped, h history, * valid, > best, i -
internal
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
* 200.200.1.0 200.200.2.1 0 0 100 i
* 200.200.1.1 0 0 100 i
*> 0.0.0.0 0 32768 i Where
did I pick up the Static/Default paths from
* 200.200.2.0 200.200.2.1 0 0 100 i
* 200.200.1.1 0 0 100 i
*> 0.0.0.0 0 32768 i Where
did I pick up the Static/Default paths from
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=27879&t=27879
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
