Thank you Allen and Christopher. Based on Allen's tip, I used the following link to set the dip switches right: http://www.kentrox.com/support/KB/DataSMART_T3/Public/T3E3680.htm
And it worked like a champ. Thanks, Akim "Allen May" wrote: > It's either an S register (or was it an AT?) command you save to flash for > the default config or it may have dip switches to enable auto-answer. First > check for dip switches. If there are none then look up the S register > configs & how to save the settings. It's been so many years since I messed > with those settings that I'm a bit rusty on it. > > > ----- Original Message ----- > From: A.Steinbock > To: > Sent: Sunday, December 16, 2001 12:20 AM > Subject: Conneitng to a router's AUX port [7:29323] > > > > I am connecting to the aux port of my router through a dialup modem. > > When the aux port is connected to a Hayes modem, everything works fine. > > When I use a USrobotics Sportster modem the line keeps on ringing with no > > answer. > > Does anyone know why this could happen and what command shoudl I send to > the > > modem to make it behave? > > > > TIA > > Akim > > > > > > ____________________________________________________________________ > > Get free e-mail and a permanent address at http://www.amexmail.com/?A=1 ____________________________________________________________________ Get free e-mail and a permanent address at http://www.amexmail.com/?A=1 Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=29327&t=29323 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
