David, make sure that you don't have the following line in you PIX config. I had a summary problem with a PIX 501 with 6.1 IOS, only I wanted to use NAT. I had private workstations that could not get out to the Internet unless PAT was enabled, NAT would not work. After spend 4 hours on the Phone with Cisco support, we discovered that this line shouldn't be in the configuration unless you are using PAT. It was placed on the PIX as part of the default configuration.
sysopt noproxyarp outside > ----- Original Message ----- > From: "David Tran" > To: > Sent: Monday, December 17, 2001 16:13 > Subject: how to disable NAT in PIX firewall (both inside an [7:29303] Why it is not working is a mystery to me. I have a workstation on the same network as the outside interface, the workstation has an IP address of 66.61.46.150 with the default gateway points to 66.61.46.254. Guess what, the workstation can get to the Internet just fine but workstation on the "inside" interface can not. Strange thing is that the pix can ping the Internet (4.2.2.2) as well. Any more ideas. Thanks. Donald R. Queen CCA,CCNA,MCSE,CNE5 Baker Robbins & Company Technology Consultants Knowledge, Solutions, Partnership [EMAIL PROTECTED] 713.840.0510 This transmission and all attachments are the copyrighted materials of Baker Robbins & Company. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=29662&t=29408 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
