Yes if you don't add the route statement it won't work, (route). Dave
Hunt Lee wrote: > > I'm a bit confused on the the following IRB commands: > > In Caslow (p612), it gives the following IRB config example: > > (Config)# bridge irb > (Config)# interface bvi 1 > (Config)# bridge 1 bridge ipx > > But I thought the whole purpose of BVI is to route packets from the Bridge > group to the BVI itself, and then the BVI will forward the packet to the > outbound routed interface, so shouldn't the last command be: > > (Config)# bridge 1 route ipx > > Any help will be greatly appreciated. > > Best Regards, > Hunt Lee > IP Solution Analyst > Cable & Wireless -- David Madland Sr. Network Engineer CCIE# 2016 Qwest Communications Int. Inc. [EMAIL PROTECTED] 612-664-3367 "Emotion should reflect reason not guide it" Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=30577&t=30574 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
