What about router id's? Are they all unique? I set something up in the lab once and mistakenly made the rid's of 2 routers the same, that caused some weird stuff to happen.
~-----Original Message----- ~From: Cisco Nuts [mailto:[EMAIL PROTECTED]] ~Sent: Tuesday, January 15, 2002 6:01 PM ~To: [EMAIL PROTECTED] ~Subject: no neigbor in a ospf in a point-to-multipoint mode ?? ~[7:32089] ~ ~ ~Hello, ~Just reconfigured my 3 routers from non-broadcast to ~point-to-multipoint ~mode. Can see the routes on all 3 routers and can actually ~ping from RTA to ~RTC's networks fine and vice-versa.(RTB is acting as the hub). ~Problem is I don't see RTA forming a neighbor relationship ~with RTC and ~vice-versa but pings work fine!! ~ ~RTA#sh ip ospf nei ~ ~Neighbor ID Pri State Dead Time Address ~ Interface ~N/A 0 DOWN/ - - 7.7.7.2 ~ Serial0 ~9.9.9.9 1 FULL/ - 00:01:48 7.7.7.1 ~ Serial0 ~ ~RTA#ping 16.16.16.1 -----------(RTC's loopback ip) ~ ~Type escape sequence to abort. ~Sending 5, 100-byte ICMP Echos to 16.16.16.1, timeout is 2 seconds: ~!!!!! ~Success rate is 100 percent (5/5), round-trip min/avg/max = ~116/116/116 ms ~ ~Why is this working without RTA forming a neighbor with RTC? ~ ~Please advise. ~ ~Thank you. ~ ~ ~ ~_________________________________________________________________ ~Chat with friends online, try MSN Messenger: http://messenger.msn.com ~ ~ ~ ~ ~Report misconduct ~and Nondisclosure violations to [EMAIL PROTECTED] ~ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=32095&t=32095 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
