Well, I have one of those GL3's, and it's a pretty good piece of work. I would agree that the documentation accompanying that switch is somewhat sparse. It took me quite a while to 'figure it out' on my first setup. The below assumes an IP network.
If I remember correctly, those docs talked about irb enabling. Syntax: bridge irb Then the bridge: bridge (xx) protocol ieee ; for example for subnet 10.0.11.0/24; bridge 11 protocol ieee Then pop the interface config: int BVIxx ;Bridge Virtual Interface ip address xx.xx.xx.xx (netmask) ; example "int BVI11, ip address 10.0.11.1 255.255.255.0" If I were to route these VLANS, internally, I'd have to add a statement whilst creating the bridge. This is where the routing happens, or, as you require, doesn't happen: bridge xx protocol ieee bridge xx route ip Without the "route" statement, routing doesn't occur between other VLANs. Finally, each interface needs to have VLAN membership. At the interface config: bridge group xx Took me a while to get all that right.... Best, G. ject: VLAN's [7:32351] > > > Have a 2948GL 3 and want to set up a vlan but it docs state > that you have to > set up ISL . I don't want ISL enabled. is there a way to > just create VLANS > like in other L3 switches? I don't want to make these > routeable or anything > just L2 VLANS simple VLANS > > ie. when I do a "int vlan 400" this would normally create a > new vlan and put > me into interface mode > > when i do a "int vlan ?" the options are to put in the vlan > # but when I do > all i get is a wrong command with the famous ^ at the vlan > point in the > command > > docs doc's dont seem to give enough info > > any Ideas???? > > thanks Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=32377&t=32351 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
