Ok here is where we're at:
We've never had this RSM with a proper image. The first time we booted it
there was only a boot image on it (c5rsm-boot-mz.112-12a.P1.bin), so we
don't know if there was some pre-existing hardware problem with our VIP2
card.
With the old 11.2 *boot* image we didn't receive a boot error and
software does get loaded onto the VIP2 (sw ver 22.20). We can't see the
amount of memory on it and the microcode status is 0x4 (all from sh diag).
Also we can't see the ATM PAM interface, though the enabled light is on.
We installed the c5rsm-jsv-mz.122-3.bin and we didn't have enough DRAM on
the RSM (only 32M) to support it so we reloaded the other image we had into
the RSM (c5rsm-jsv-mz.121-10.bin) and we received these errors during
bootup:
***CUT FROM CONSOLE***
%VIP-3-SVIP_RELOAD: VIP2 slot9 : SVIP Reload is called.
%VIP-3-SYSTEM_EXCEPTION: VIP2 slot9 : VIP System Exception occurred sig=10,
code
=0x1C, context=0x605154A4
%CBUS-3-CCBPTIMEOUT: CCB handover timed out, CCB 0x5800FFB0, slot 9
-Traceback= 602E6454 602E3B18 602E416C 602DB3E8 60269744 601C1C70 601C1E48
60249
B44 60249B30
***END CUT FROM CONSOLE***
We also did a sh diag and saw that the "board is disabled wedged" and the
memory amount is unknown (like before), and this time, it doesn't say the sw
version (under sh cont cbus) and the microcode status is 0x5. Also shown
under sh diag is:
=== Flushing messages (00:00:01 UTC Mon Mar 1 1993) ===
Queued messages:
No fault history 0xFFFFFFFF. Need 11.1 (2) or
higher ROM
Under 12.1, this is what a sh cont vip all log displays (there isn't a sh
cont vip all log under 11.2 so I didn't get output from that version of
IOS):
show logging from Slot 9:
%Failed to connect to remote console : no such port
I *think* we have the VIP2-15 because it has one SRAM slot and two DRAM
slots, thereby having 1MB of SRAM and 16MB of DRAM. (as a side note, what's
the SRAM for?).
I apologize for the spam, but I don't know any other way to provide you
with enough info to diagnose this problem. I have edited out as much
information as possible. If there is some information that I left out that
would be important to see, let me know. I'm really not sure where to go
next.
Thanks,
Joe
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=34593&t=34511
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
