I've set up a similar lab with 2611's with those cards installed. I had the same problem when I was using a short cable, 6 feet. I increased the length of the cable to 20 feet and the circuit came up. I then used my old crossover cable on a router that had an external csu to see if the cable was bad and it wasn't. I would try using a longer crossover cable.
Woody -----Original Message----- From: Mark Odette II [mailto:[EMAIL PROTECTED]] Sent: Thursday, February 14, 2002 3:21 PM To: [EMAIL PROTECTED] Subject: back-to-back Wic-1DSU-T1 Snaffu... [7:35431] Ok guys and gals...Here's the situation that I hope someone can slap me on the back of the head and go, you dummy, you forgot to do that! ... and then tell me what to do to fix it. I have two 1700 routers with 12.1.5YBx IOS code running, and each has a WIC-1DSU-T1 card in them. Very simple Back-To-Back lab... at least you would think. I've double-checked to make sure that my STP cable has pins 1,2 and 4,5 reversed... 1 to 4 (wire color orange/white) and 2 to 5 (wire color solid orange). I've put in on one router only, the Service-Module T1 Clock Source Internal command, and have even gone the extra measure of hand coding the line code, and frame commands - B8ZS and ESF. I've changed the LBO to none, and -15db on both units in mirror image fashion. I've specified Timeslots All and Timeslots 1-24 speed 64 on both routers in mirror fashion. Still.... NADA. The following is the config's and their associated Show Service Module S0 outputs. Somebody, please tell me what the heck I'm doing wrong!! I can configure this on the old DB60 cabling configuration all day long with no problem at all. ------------------------------------------------ Router A: interface Serial0 ip address 10.1.1.1 255.255.255.252 encapsulation ppp service-module t1 lbo -15db service-module t1 timeslots 1-24 RouterA#sh int s0 Serial0 is down, line protocol is down Hardware is PQUICC with Fractional T1 CSU/DSU Internet address is 10.1.1.1/30 MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set Keepalive set (10 sec) LCP Closed Closed: IPCP, CDPCP Last input 01:07:20, output 01:07:20, output hang never Last clearing of "show interface" counters 00:48:15 Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: weighted fair Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/1/256 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 1152 kilobits/sec 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 98 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions DCD=down DSR=up DTR=up RTS=up CTS=down RouterA#sh service-module s0 Module type is T1/fractional Hardware revision is 0.88, Software revision is 0.2, Image checksum is 0xED22BEC5, Protocol revision is 0.1 Transmitter is sending remote alarm. Receiver has loss of frame, Framing is ESF, Line Code is B8ZS, Current clock source is line, Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536 Kbits/sec. Last user loopback performed: no loopback duration 01:49:32 Last module self-test (done at startup): Passed Last clearing of alarm counters 00:55:40 loss of signal : 0, loss of frame : 1, current duration 00:55:40 AIS alarm : 0, Remote alarm : 0, Module access errors : 0, Total Data (last 18 15 minute intervals): 2746 Line Code Violations, 510 Path Code Violations 1185 Slip Secs, 9840 Fr Loss Secs, 6636 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 3 Severely Err Secs, 9837 Unavail Secs Data in current interval (606 seconds elapsed): 0 Line Code Violations, 0 Path Code Violations 0 Slip Secs, 606 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 606 Unavail Secs RouterB: interface Serial0 ip address 10.1.1.2 255.255.255.252 encapsulation ppp no ip route-cache no ip mroute-cache no fair-queue service-module t1 clock source internal service-module t1 lbo -15db service-module t1 timeslots 1-24 RouterB#sh int s0 Serial0 is down, line protocol is down Hardware is PQUICC with Fractional T1 CSU/DSU Internet address is 10.1.1.2/30 MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set Keepalive set (10 sec) LCP Closed Closed: IPCP, CDPCP Last input never, output never, output hang never Last clearing of "show interface" counters 00:53:57 Queueing strategy: fifo Output queue 0/40, 0 drops; input queue 0/75, 0 drops 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 1 interface resets 0 output buffer failures, 0 output buffers swapped out 0 carrier transitions DCD=down DSR=up DTR=up RTS=up CTS=down RouterB#sh service-module s0 Module type is T1/fractional Hardware revision is 0.96, Software revision is 0.2, Image checksum is 0xED22BEC5, Protocol revision is 0.1 Transmitter is sending remote alarm. Receiver has loss of signal, loss of frame, Framing is ESF, Line Code is B8ZS, Current clock source is internal, Fraction has 24 timeslots (64 Kbits/sec each), Net bandwidth is 1536 Kbits/sec. Last module self-test (done at startup): Passed Last clearing of alarm counters 00:53:13 loss of signal : 1, current duration 00:53:04 loss of frame : 1, current duration 00:53:04 AIS alarm : 0, Remote alarm : 0, Module access errors : 0, Total Data (last 3 15 minute intervals): 440 Line Code Violations, 0 Path Code Violations 20 Slip Secs, 2700 Fr Loss Secs, 97 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 2700 Unavail Secs Data in current interval (487 seconds elapsed): 0 Line Code Violations, 0 Path Code Violations 0 Slip Secs, 487 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 487 Unavail Secs Thanks, Mark Odette II Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=35440&t=35431 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
