Hi, I have a few questions regarding Sybex CCNP Virtual Lab.
SWITCHING: GENERAL INFO: a) How many Catalyst 5000 switches can you configure in the software? b) If more than 1, can you create a dual core with layer 2 / layer 3? c) What is the supervisor revision number? d) What software release is used? e) When typing a question mark and pressing enter, do you get command help (on all the commands)? LAYER 3 SWITCHING: How is layer 3 switching accomplished? a) With a NFFC card + a router b) With the NFFC and a Router Switch Module VIP Module: a) Does the 5000 support a VIP card? b) If yes is it version 1 or 2? HSRP a) Can you do HRSP? MULTICAST a) Is there a multicast server on the network that can be used to simulate multicast traffic? b) Can you display the multicast route on all the routers c) Can you configure PIM in dense mode / sparse mode? d) Can you use debug? ROUTING: a)Which routing protocols are supported? (rip version 1/2, igrp, eigrp, ospf, bgp) b) Can you put your routers in whatever configuration pleases you and have them do routing properly? c) How manyt routers do you have available? d) What model of routers can you use (or what interfaces are available on each routers) e) What IOS is used on the routers? f) What protocols are supported? IP / IPX / Apple Talk .... g) Can you do access-lists, route maps, distribute-list, null interfaces, passive interfaces, prefix list .... REMOTE ACCESS a) How many ISDN routers can you have connected at the same time? b) What ISDN features can you configure on the routers: TROUBLESHOOGING a) What troubleshooting case scenario can you emulate on the software? b) Can you use debug on the equipment ANY COMMMENT YOU WANT TO MAKE ON THIS SOFTWARE: Thank you, Pierre-Alex Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=39527&t=39527 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
