I believe you are right... You are working on a ROUTER, therefore, it prefers to ROUTE ROUTABLE traffic. If you take the ROUTING option away, then it will attempt other configured methods of forwarding traffic.
--Tim Priscilla Oppenheimer wrote: > > At 11:50 AM 4/6/02, nntp.groupstudy.com wrote: > >I put two FA interfaces into same bridge group, and enable > bridge protocol > >ieee. There is not IP address configured on the bridge port. > But it will > >not > >bridge any IP traffic unless I disable IP routing on the router > > I think that's normal. If you want to bridge IP, you must > disable IP > routing because IP routing is enabled by default. See this: > > http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fibm_c/bcfpart1/bcftb.htm#xtocid30 > > >or use bridge > >irb. I was expecting the bridged ports will bridge IP, > because there is no > >IP configured on these two interface. Can somebody explain > why? > > > >Thanks > > > >Ruihai > ________________________ > > Priscilla Oppenheimer > http://www.priscilla.com > > Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=40828&t=40709 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
