I think you can do it in 2 ways: 1) using dynamic crypto map. Here is a link which describe how to set up it !!! http://www.cisco.com/warp/public/707/ios_804.html 2) If u have public ip addresses say on ur ethernet side or a pool assigned to by ISP. U can use that on either on ethernet or loopback address and use this address to initiate and terminate tunnels.
Command for this is cyptoma map local-address x.x.x.x --- Craig Columbus wrote: > Is it possible to setup a router to PIX VPN when the > router is obtaining a > dynamic WAN interface address (in this case ISDN > dial-up)? > If so, has anyone done this? How do you define the > peer when you don't > know the peer address? Is it possible to allow any > host to create a tunnel > provided that the pre-shared key is known? > > Thanks in advance for your comments! > > Craig > _________________________________________________________________ > Commercial lab list: > http://www.groupstudy.com/list/commercial.html > Please discuss commercial lab solutions on this > list. > __________________________________________________________________ > To unsubscribe from the CCIELAB list, send a message > to > [EMAIL PROTECTED] with the body containing: > unsubscribe ccielab __________________________________________________ Do You Yahoo!? Yahoo! Games - play chess, backgammon, pool and more http://games.yahoo.com/ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=42267&t=42267 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
