I have a network where corporate is connected to 3 branch offices through Point to Point. The branch office are also connected together in a full mesh frame-relay toplogy as a backup. The corporate office is also connected to few other small branches in a hub and spoke frame-relay topology. I was running IPX RIP by default between those networks and response time between IPX hosts and servers was not really bad. I decided to make some more changes to decrease the latency by configuring IPX eigrp between WAN Links only and left RIP on LAN interfaces. Instead of decreasing the latency it increased it by 4 times. Before EIGRP I copied a file and it took about 20 seconds. Now it's taking almost 4 minutes. I am curious where I went wrong.
All I did to enable IPX Router eigrp 2 advertised all my WAN networks. network xxxx network xxxx and so on. I then removed those WAN networks from RIP routing by IPX router rip no network xxxx no network xxxx and so on. Note: I am also running EIGRP 1 for IP network. I don't think that it will conflict since both have under different Autonomous systems. Any suggestions folks. Regards, Ab Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=42735&t=42735 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
