Does someone know of a link where I can learn how to interpet all the
details of a show interface command? I know its kinda simple , but need to
know what it all means. Like here's an example. The top part is self
explanatory but the lower part is where I do not uderstand.
sh int fastEthernet 0/1
FastEthernet0/1 is up, line protocol is up
Hardware is Fast Ethernet, address is 00d0.ba51.0401 (bia 00d0.ba51.0401)
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set
Half-duplex, 100Mb/s, 100BaseTX/FX
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:45, output 00:00:01, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 17000 bits/sec, 2 packets/sec
5 minute output rate 2000 bits/sec, 3 packets/sec
11696790 packets input, 588816475 bytes, 0 no buffer
Received 27194 broadcasts, 1560 runts, 0 giants, 0 throttles
1 input errors, 1 CRC, 0 frame, 0 overrun, 30 ignored, 0 abort
0 watchdog, 15688 multicast
0 input packets with dribble condition detected
10445904 packets output, 1959387521 bytes, 0 underruns
0 output errors, 1320 collisions, 1 interface resets
0 babbles, 0 late collision, 9674 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
thanks
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=44459&t=44459
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
