Since this is a Sup. Blade that you just acquired, what about just wiping the config completely??
Either a "write erase" or a "clear config all" after you've gotten on the thing in enable mode might be your best bet. When you reload the switch afterwards, it should come up with factory default settings/config... which means your passwords will be blank. Just a thought... Mark -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Stuart Laubstein Sent: Wednesday, May 22, 2002 7:39 AM To: [EMAIL PROTECTED] Subject: AW: set password problem [7:44702] I tried that but it tells me incorrect password--the enablepass seems to work though -----Urspr|ngliche Nachricht----- Von: Richard Botham [mailto:[EMAIL PROTECTED]] Gesendet am: Wednesday, May 22, 2002 2:17 PM An: [EMAIL PROTECTED] Betreff: RE: set password problem [7:44702] Stuart, You can press enter during the 1st 30 seconds ( No later) which will get you into the CAT and then you can reset the password(s) HTH Richard Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=44716&t=44702 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
