What's the sho ver say? Sometimes- the FLASH will show in a read only state. There are a lot of little variables that cause this. Assuming you do have the proper 11.0(10c) ROMs and 16/16 FLASH and RAM, you may want to start by wiping or delete the existing image and loading it fresh.
Another option away from the TFTP software would be to make an adjacent 2500 a TFTP server. The command would be- r7(config)#tftp-server flash: Just a few thoughts... Phil -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Justin M. Clark Sent: Sunday, May 26, 2002 7:56 PM To: [EMAIL PROTECTED] Subject: IOS Install Problems [7:45102] I have a 2501 purchased from Ebay with c2500-js-l.122-7b.bin installed on it. Just for standards I wish for all my routers to have the same IOS on it. I have been trying to load c2500-jos56i-l.121-6.bin on it. I have tried to install it from 2 different TFTP servers and FTP and none of them will work. Cisco TFTP says "State Error" and solar winds TFTP says connection reset by remote peer. It looks like it copies a little chunk of it then kicks back those errors. 2-3 exclamations is all I get on the router. I have not problem copying the IOS off of the router, but can't seem to get one on it. Does anyone have any suggestions? Thanks, Justin Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45110&t=45102 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
