You can't change the duplex and speed on a 2500. It's too old.
""Kenny Smith"" wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Dear all, > > Question1: May I know how to set the speed and duplex type of the interface > ethernet0 of 2500 router. See below.. there is no speed and duplex option > unlike IOS switch fasthernet switch. > > internetRT(config)int e0 > internetRT(config-if)#? > Interface configuration commands: > access-expression Build a bridge boolean access expression > arp Set arp type (arpa, probe, snap) or timeout > backup Modify dial-backup parameters > bandwidth Set bandwidth informational parameter > bridge-group Transparent bridging interface parameters > cdp CDP interface subcommands > cmns OSI CMNS > custom-queue-list Assign a custom queue list to an interface > delay Specify interface throughput delay > description Interface specific description > exit Exit from interface configuration mode > frame-relay Set frame relay parameters > help Description of the interactive help system > hold-queue Set hold queue depth > ip Interface Internet Protocol config commands > ipx Novell interface subcommands > keepalive Enable keepalive > llc2 LLC2 Interface Subcommands > load-interval Specify interval for load calculation for an interface > loopback Configure internal loopback on an interface > mac-address Manually set interface MAC address > mtu Set the interface Maximum Transmission Unit (MTU) > netbios Use a defined NETBIOS access list or enable > name-caching > no Negate a command or set its defaults > ntp Configure NTP > priority-group Assign a priority group to an interface > shutdown Shutdown the selected interface > snapshot Configure snapshot support on the interface > snmp Modify SNMP interface parameters > standby Hot standby interface subcommands > transmit-interface Assign a transmit interface to a receive-only > interface > tx-queue-limit Configure card level transmit queue limit > > internetRT(config-if)# > > Question2, > When I config my solaris box's (boxA) hme0 as IP 61.9.200.114 netmask > 255.255.255.240 broadcast 61.9.200.127. But it keep changed to 61.9.200.114 > netmask 255.0.0.0 broadcast 61.255.255.255 after reboot. May I know why? I > configure it on another solaris (boxB) but it stays as 61.9.200.114 netmask > 255.255.255.240 broadcast 61.9.200.127 after rebooting. Why box A netmask > changed? > > _________________________________________________________________ > MSN Photos is the easiest way to share and print your photos: > http://photos.msn.com/support/worldwide.aspx Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45242&t=45242 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
