Zahid,
The 'show interface' command would show the actual going through the
interface.
You probably are after the 'show interface xxxx rate-limit' command
instead [shown here on 12.2(7a)]:
milliways#show int f0/0.102 rate-limit
FastEthernet0/0.102
Input
matches: all traffic
params: 128000 bps, 24000 limit, 32000 extended limit
conformed 200597 packets, 36550102 bytes; action: transmit
exceeded 616 packets, 895075 bytes; action: drop
last packet: 59244ms ago, current burst: 7483 bytes
last cleared 2w6d ago, conformed 0 bps, exceeded 0 bps
Output
matches: all traffic
params: 128000 bps, 24000 limit, 32000 extended limit
conformed 220716 packets, 103342492 bytes; action: transmit
exceeded 7757 packets, 11884318 bytes; action: drop
last packet: 59168ms ago, current burst: 0 bytes
last cleared 2w6d ago, conformed 0 bps, exceeded 0 bps
milliways#
Zahid Hassan wrote:
>
> Dear All,
>
> I would really appreciate if someone would shed some light into my
following
> question:
>
> I have configured rate-limit on an interface. When I do show interface
fa0/0,
> do I see the
> number of bit/s under the 5 min input and output rate after the rate-limit
> has
> been applied or the
> actual bits/s the interface is receiving or transmitting ?
>
> Thanks in advance,
>
> Zahid
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=45718&t=45716
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
