Is there some function that can filter NetBEUI traffic through a router/bridge based on packet size that can get set without user intervention? I have RSB (both simple and multi-port RSB show the same symptoms) configured on a 7010/RSP w/ an old four-port CX Token interface board. I am bridging two switched TrCRFs from an Olicom 8600 (under separate TrBRFs). I am using Win2k NetBEUI clients (no IP). When I do a packet capture of a network browse/drive mapping session, I see lots of traffic going through the bridge (using MS NetMon on either side of the bridge, I see NetBIOS and LLC going back and forth), but none of my actions are successful. Browses and mappings do not complete. The largest frame that I can see traversing the bridge is 68 bytes. Frames 102 or larger do not make it through the bridge. This is the only difference that I can see between packets that make it through and those that don't. The bridge MTU is set to 4096 bytes. There are no access lists set. I have seen this behavior on a 7007 also running a CX card. I have no other multi-port token systems to test it with. Any help will be greatly appreciated.
Thank you, Nelson R. Herron Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=45994&t=45994 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
