Perhaps you have only a 2V DSP chip in the router (PN=PVDM-4)!?!? Issue a Show Diag at the Exec Mode prompt, and see if it says DSPs = 2 or 4.
If it's 2, then that answers your question about not being able to configure more then 2 voice ports. But, somehow I would think that if you only had 2 DSPs, then you would only have 2 of the 4 FXS ports initialized. Perhaps you should do a "wr era" (if it's not a production router) and then bounce that bad boy to see if you get different results. You might even see about rolling back to 12.2(4)T and see if that makes a difference. Mark -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of George Siaw Sent: Thursday, June 06, 2002 7:19 PM To: [EMAIL PROTECTED] Subject: FXS cards - 1751 [7:45977] Guy, Any ideas why there are only to voice ports to be configured? Runcorn-1750>sh ver Cisco Internetwork Operating System Software IOS (tm) C1700 Software (C1700-K8SV3Y7-M), Version 12.2(8)T1, RELEASE SOFTWARE (fc2) TAC Support: http://www.cisco.com/tac Copyright (c) 1986-2002 by cisco Systems, Inc. Compiled Sat 30-Mar-02 15:07 by ccai Image text-base: 0x80008108, data-base: 0x80F66930 ROM: System Bootstrap, Version 12.0(3r)T1, RELEASE SOFTWARE (fc1) Runcorn-1750 uptime is 0 minutes System returned to ROM by power-on System image file is "flash:c1700-k8sv3y7-mz.122-8.T1.bin" cisco 1750 (MPC860T) processor (revision 0x801) with 36864K/12288K bytes of memory. Processor board ID JAD06090DEV (2308858941), with hardware revision 0000 MPC860T processor: part number 0, mask 32 Bridging software. X.25 software, Version 3.0.0. 1 FastEthernet/IEEE 802.3 interface(s) 1 ATM network interface(s) 4 Voice FXS interface(s) 32K bytes of non-volatile configuration memory. 16384K bytes of processor board System flash (Read/Write) Configuration register is 0x210 Regards, George. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=46093&t=45977 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
