In my experience, what you are seeing is correct. Every L1/L2 router sets the ATT bit in its LSPs. The L1 router see this and chooses the router with the lowest metric and ATT bit set as its default route. No additional configuration should be required.
Hope this helps. On Wed, 12 Jun 2002, Cisco Nuts wrote: > Hello, > > Had a question on default-info originate in ISIS? Does a Level-1 router > automatically get a default route from a Level-1-2 router? I read somewhere > that you had to configure the default-info originate cmd. (similiar to in > OSPF) on a Level-1-2 router so it could advertise this to other Level-1 > routers inside the area. > > But in my case, when I do a sh ip route on a Level-1 router, I see a default > route pointing to the Level-1-2 router without me actually configuring this > command! Is this the case? > > Please advise. > > Level-1 router: > RTC#sh ip route > > > i*L1 0.0.0.0/0 [15/10] via 10.10.15.254, Multilink1 > > > This ip addr. 10.10.15.254 is the Level-2 router(Lo0) that this router > connects via a Multilink intf. > > > > > > _________________________________________________________________ > Join the worlds largest e-mail service with MSN Hotmail. > http://www.hotmail.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=46416&t=46380 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
