Here are some further inputs from my side.
This is a pt -to -pt Leased Line.
The CSU/modem is configured for 256kbps. it shows on the router also as
clockrate 256000 as per below output.
#sh controllers ser2/6
M8T-V.35: show controller:
PAS unit 6, subunit 6, f/w version 3-0, rev ID 0x2800001, version 3
idb = 0x62AF6C58, ds = 0x62AF8960, ssb=0x62AF8C38
Clock mux=0x0, ucmd_ctrl=0xC, port_status=0x74
Serial config=0x8, line config=0x302
maxdgram=1608, bufpool=32Kb, 64 particles
DCD=up DSR=up DTR=up RTS=up CTS=up
line state: up
cable type : V.35 DTE cable, received clockrate 256086
Also when i am saying 320000 bps it only either the i/p or o/p rate and not
the sum of the two.
sample as below
5 minute input rate 312000 bits/sec, 6 packets/sec
5 minute output rate 120000 bits/sec, 5 packets/sec
----- Original Message -----
From: "YASSER ALY"
To:
Sent: Wednesday, July 10, 2002 12:45 AM
Subject: RE: interface traffic showing unreasonable statistics [7:48397]
> If it is the summ of the average input & the average output this will be
> ok as already mentioned here that the link is full duplex, so expect to
> get max 256 in & 256 out at the same time if you have such traffic.
>
> However, if you just mean that the 320000 was the traffic of either the
> input or the output only then there is something wrong here. If this is
> the case then most probable that your ISP is letting you burst over the
> contracted 256K - lucky you :) - either intentionally or by mistake.
>
> If the line speed is higher than the 256K and again the provider is not
> rate-limiting the traffic from his side, then you will be able to go as
> far as the line speed can support.
>
> Give us some feedback on the line speed, the type of the circuit (
> Frame-Relay, leased-line),
>
> whether this is the only circuit terminated on that interface or there
> are many others.
>
>
>
> > > Hi all,
>
> > > I am using a cisco router with a frac-E1 link terminated on it > >
> (256kbps). I am > > running some Ipsec tunnels > > across this link.
> Sometimes i have found that i/p o/p rate > > shows more then > > 256kbps
> using the show interface ser command. > >Do you mean that the combined
> input/output rate exceeds 256 kbps? That could >be normal. It's full
> duplex. The capacity is available in both directions on >point-to-point
> WAN circuits. > >Priscilla > > > > > i have seen it upto 320000 bps? > >
> > > Plz can somebody explain this? > > thanks /regards, > > > > Uday > >
> misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> ------------------------------------------------------------------------
>
> Chat with friends online, try MSN Messenger: Click Here
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=48502&t=48397
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
