We had a couple of routers that would randomly reboot, and after rebooting a show ver showed "system restarted by bus error". I dug around on Cisco's site and found a page that said many bus errors are memory errors. I traced the address down to a stick of RAM, replaced it and was fine afterwards.....
Check out: (may wrap) http://www.cisco.com/warp/public/122/crashes_buserror_troubleshooting.shtml http://www.cisco.com/warp/public/63/ts_buserror.html There are many good links at the bottom of the first web page.... Both of these pages was found by searching Cisco's site with the keywords "3600 bus error" HTH, Mike W. wrote in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]... > Dear friends: > > My CISCO 3640 is rebooting frequently. I receive the following message: > > -------------------------------------------------------------------------- --- > -------------------------------------------------------------------------- --- > ---------------------- > > === Flushing messages (03:06:53 UTC Mon Mar 1 1993) === > > Queued messages: > No fault history 0xFFFFFFFF. Need 11.1 (2) or higher ROM > > -Traceback= 60993B90 609949DC 6098041C 60980910 604C98A8 604C9B7C 604C9D08 > 6040D > E0C 6040DDF8 > *** System received a Bus Error exception *** > signal= 0xa, code= 0x10, context= 0x60fe4740 > PC = 0x60436d74, Cause = 0x420, Status Reg = 0x34018002 > > System Bootstrap, Version 11.1(20)AA2, EARLY DEPLOYMENT RELEASE SOFTWARE > (fc1) > Copyright (c) 1999 by cisco Systems, Inc. > C3600 processor with 131072 Kbytes of main memory > Main memory is configured to 64 bit mode with parity disabled > > program load complete, entry point: 0x80008000, size: 0x583cdc > Self decompressing the image : > ################################################# > ############################################################################ # > ### > ############################################################################ # > ### > ############################################################################ # > ### > ############################################################################ # > ### > ############################################################################ # > ### > ############################################### [OK] > > Smart Init is enabled > smart init is sizing iomem > ID MEMORY_REQ TYPE > 000044 0X0004FE00 Single Port Fast Ethernet > 000044 0X0004FE00 Single Port Fast Ethernet > 00006F 0X00012580 Sixteen port A/D Modem > 00006F 0X00012580 Sixteen port A/D Modem > 0X0010A6F8 public buffer pools > 0X00211000 public particle pools > TOTAL: 0X003DFDF8 > > If any of the above Memory Requirements are > "UNKNOWN", you may be using an unsupported > configuration or there is a software problem and > system operation may be compromised. > Rounded IOMEM up to: 4Mb. > Using 3 percent iomem. [4Mb/128Mb] > > Restricted Rights Legend > > Use, duplication, or disclosure by the Government is > subject to restrictions as set forth in subparagraph > (c) of the Commercial Computer Software - Restricted > Rights clause at FAR sec. 52.227-19 and subparagraph > (c) (1) (ii) of the Rights in Technical Data and Computer > Software clause at DFARS sec. 252.227-7013. > > cisco Systems, Inc. > 170 West Tasman Drive > San Jose, California 95134-1706 > > > > Cisco Internetwork Operating System Software > IOS (tm) 3600 Software (C3640-I-M), Version 12.1(5)T, RELEASE SOFTWARE (fc1) > Copyright (c) 1986-2000 by cisco Systems, Inc. > Compiled Sat 11-Nov-00 01:38 by ccai > Image text-base: 0x60008950, data-base: 0x60A26000 > > cisco 3640 (R4700) processor (revision 0x00) with 126976K/4096K bytes of > memory. > Processor board ID 15635903 > R4700 CPU at 100Mhz, Implementation 33, Rev 1.0 > Bridging software. > X.25 software, Version 3.0.0. > 2 FastEthernet/IEEE 802.3 interface(s) > 32 terminal line(s) > DRAM configuration is 64 bits wide with parity disabled. > 125K bytes of non-volatile configuration memory. > 8192K bytes of processor board System flash (Read/Write) > > -------------------------------------------------------------------------- --- > -------------------------------------------------------------------------- --- > ---------------------- > > Do you know where is the problem? > > > Regards,, > > Ing. Joseba M. Izaga K|hn > Gerente de Operaciones > Alfanumeric, S.A. > Tel.: (505) 278-3200 Ext. 300 > Fax: (505) 278-5857 > [EMAIL PROTECTED] > www.alfanumeric.com.ni Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=49211&t=49163 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
