Richard, You need to boot the 2501 router into RXBoot mode before you can Upgrade the IOS in Flash.
Visit this CCO URL: http://www.cisco.com/warp/public/130/sw_upgrade_proc_flash.shtml Here is probably the cause of your problem: ---------------------------------------------------------------------------- ---------------------------------------------- Configure the router or access server to boot into Rxboot mode On these platforms, the Cisco IOS software image is actually running directly from the Flash memory. Therefore, you cannot copy the Cisco IOS software image from the TFTP server to the Flash if you are in user privileged EXEC mode (router#). You have to configure the router or access server to boot into Rxboot mode. Check the current value of the configuration register. You can see it on the bottom line of the show version output. It is usually set to 0x2102 or 0x102. You will need this value for a later step. Change the configuration register to the value 0x2101 as follows: Router>enable Password: password Router# Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#config-register 0x2101 Router(config)#^Z Router# %SYS-5-CONFIG_I: Configured from console by console !--- It's not necessary to !--- save the configuration here, as the configuration register has already !--- been changed in NVRAM Router#reload Note: If you are connected through Telnet, the session is lost after the reload. Wait a few minutes and try again. It is strongly recommended that you do not perform a Cisco IOS software upgrade remotely since most disaster recovery procedures require you to be physically located where the router is installed. ---------------------------------------------------------------------------- ---------------------------------------------- Good luck, Angel Leiva - MCSE, CCNP-R&S, CCNP-WAN Senior Network Systems Consultant International Network Services Irving, TX -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Thursday, August 01, 2002 11:30 PM To: [EMAIL PROTECTED] Subject: 2501 IOS Flash! [7:50512] Hey all, Could someone be kind enough to explain to me why I can't copy IOS by tftp to my flash, my flash currently reads: System flash directory: No files in System flash [0 bytes used, 16777216 available, 16777216 total] 16384K bytes of System flash (Device not programmable) I think (Device not programmable) may be the problem(could be wrong), any ideas how to rectify this? Please help. Thanks. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=50558&t=50512 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
