All,
I am trying to configure a T1 accross these 2 routers and interface types.
One is a multichannel T1 on a 7206 and the other is a serial 0 Hardware is
HD64570 on a 2524 router. Does anyone know if these two interface types are
compatable to configure a T1 accross. I set all my framing, clock source,
channel groups and timeslots to match on both sides but still can't get the
line protocol to come up. Listed below is a show interfaces on both routers.

#sh int serial 6/0:0
Serial6/0:0 is down, line protocol is down
  Hardware is Multichannel T1
  Internet address is 205.109.x.x/30
  MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
     reliability 251/255, txload 1/255, rxload 1/255
  Encapsulation PPP, crc 16, Data non-inverted
  Keepalive set (10 sec)
  LCP Closed
  Last input never, output 22:07:09, output hang never
  Last clearing of "show interface" counters 2w1d
  Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: weighted fair
  Output queue: 0/1000/64/0 (size/max total/threshold/drops)
     Conversations  0/1/16 (active/max active/max total)
     Reserved Conversations 0/0 (allocated/max allocated)
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     0 packets input, 0 bytes, 0 no buffer
     Received 0 broadcasts, 6 runts, 45 giants, 0 throttles
     63 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 4 abort
     280 packets output, 3920 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 output buffer failures, 0 output buffers swapped out
     6 carrier transitions
  alarm present
  Timeslot(s) Used:1-24, subrate: 56Kb/s, transmit delay is 0 flags
#sh int serial 0
Serial0 is up, line protocol is up
  Hardware is HD64570
  Internet address is 205.109.x.x 255.255.255.252
  MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
  Encapsulation PPP, loopback not set, keepalive set (10 sec)
  LCP Open
  Open: ipcp, cdp
  Last input 0:00:00, output 0:00:00, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/75/0 (size/max/drops); Total output drops: 15
  Output queue: 0/64/0 (size/threshold/drops)
     Conversations  0/18 (active/max active)
     Reserved Conversations 0/0 (allocated/max allocated)
  5 minute input rate 1000 bits/sec, 3 packets/sec
  5 minute output rate 1000 bits/sec, 2 packets/sec
     261883712 packets input, 2231977259 bytes, 0 no buffer
     Received 2 broadcasts, 0 runts, 0 giants
     3808 input errors, 3808 CRC, 170 frame, 0 overrun, 0 ignored, 666 abort
     228622732 packets output, 2604399815 bytes, 0 underruns
     0 output errors, 0 collisions, 1318 interface resets, 0 restarts
     0 output buffer failures, 0 output buffers swapped out
     35 carrier transitions
     DCD=up  DSR=up  DTR=up  RTS=up  CTS=up

Any suggestions appreciated.
Thanks
Randy


Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=51137&t=51137
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]

Reply via email to