This is what I am getting.... r3# 00:10:17: %LINK-3-UPDOWN: Interface TokenRing0, changed state to up 00:10:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface TokenRing0, changed state to up 00:10:26: %TR-6-STATRING: TR0: Ring Status: Down 00:10:26: %TR-3-WIREFAULT: Unit 0, wire fault: check the lobe cable MAU connection. 00:10:28: %LINK-3-UPDOWN: Interface TokenRing0, changed state to down 00:10:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface TokenRing0, changed state to down 00:10:34: %LINK-5-CHANGED: Interface TokenRing0, changed state to initializing 00:10:42: To0: Failed to initialize, shutting down 00:10:44: %LINK-5-CHANGED: Interface TokenRing0, changed state to reset 00:10:48: %LINK-3-UPDOWN: Interface TokenRing0, changed state to down
Yes I hear a click after a few seconds when the interface is trying to comes up.... I changed the cable, i connect to a diferent port..... Question, the adapter that I have in my tr interface on my router is the following: Token ring - 4/16 mb - media filter, do you think that is the correct adapter for my router. Juan -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] Sent: Friday, September 20, 2002 9:23 PM To: [EMAIL PROTECTED] Subject: RE: Token Ring [7:53774] Are you sure it's a 16 Mbps MAU? Try setting the speed to 4 Mbps with the ring-speed command. If that doesn't work, try hardcoding it back to 16 Mbps. Other than that, it's time for the "swap 'til you drop" troubleshooting methodology. Try a different: cable router interface MAU Do you hear a click after a few seconds when the interface tries to come up? That's the relay opening. If you don't hear it, then I would suspect bad hardware or hardware that's in a weird state. Years ago, Token Ring troubleshooters carried around a little reset tool, but I haven't seen one of those in years. The tool reset the port on MAUs. Mabye there's some other way to do that on your SMC MAU. Is there a reset button or anything? A couple years ago there was a discussion on Group Study regarding the same MAU, and the resolution I think was that the MAU was bad. _____________________ Priscilla Oppenheimer www.troubleshootingnetworks.com www.priscilla.com Juan Blanco wrote: > > Team, > Could any tell me what I am doing wrong....I am trying to bring > up my > token-ring interface up? I connect the TR interface with a > Token Ring > 4-16 - media filter via a rj45 strait cable to mau(smc elite > mau 4016rn), > but the interface is always in init mode and the port status > light on the > mau is switching between on and off repeatedly. > > r3#show int token0 > TokenRing0 is initializing, line protocol is down > Hardware is TMS380, address is 0008.de1c.6666 (bia > 0008.de1c.6666) > MTU 4464 bytes, BW 16000 Kbit, DLY 630 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation SNAP, loopback not set > Keepalive set (10 sec) > ARP type: SNAP, ARP Timeout 04:00:00 > Ring speed: 16 Mbps > Duplex: half > Mode: Classic token ring station > Group Address: 0x00000000, Functional Address: 0x08000000 > Ethernet Transit OUI: 0x000000 > Last input 00:01:27, output 00:01:26, output hang never > Last clearing of "show interface" counters never > Queueing strategy: fifo > Output queue 0/40, 0 drops; input queue 0/75, 0 drops > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 10 packets input, 304 bytes, 0 no buffer > Received 6 broadcasts, 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 > abort > 24 packets output, 5932 bytes, 0 underruns > 0 output errors, 0 collisions, 54 interface resets > 0 output buffer failures, 0 output buffers swapped out > 87 transitions > > > # > r3#show ip int brief > Interface IP-Address OK? Method Status > Protocol > Ethernet0 unassigned YES NVRAM > administratively down > down > Serial0 unassigned YES NVRAM > administratively down > down > Serial1 unassigned YES NVRAM > administratively down > down > TokenRing0 unassigned YES NVRAM > initializing > down > r3# > r3# > > > Thanks, > > > > JB > > > > > > Juan Blanco > ******************************************************************** > The greatest glory in living lies not in never falling, > but in rising every time we fall ." > -- Nelson Mandela > ******************************************************************** Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=53783&t=53774 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
