If these are indeed PVP's being supplied, then you should be able to check PNNI to make sure everyone sees each other. You PNNI masking may be off, double check everyone has the same PNNI level mask applied to the NSAP Nodes.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Bill Smith Sent: Wednesday, October 09, 2002 5:37 PM To: [EMAIL PROTECTED] Subject: RE: ATM Problem [7:55238] Eric, I appreciate your help..... SITE A--PINGS ALL SITES SITE C-- PINGS ALL but "new site" NEW SITE--PINGS SITE A ONLY -----Original Message----- From: Erick B. [mailto:[EMAIL PROTECTED]] Sent: Wednesday, October 09, 2002 8:30 PM To: Bill Smith; [EMAIL PROTECTED] Subject: RE: ATM Problem [7:55238] Bill, No problem. Well, lets start by trying to ping sites a, b and C from the new sites router console/telnet session. This way the ping is direct. If were able to do this then the PVC and map-list entries are correct. If the above doesn't work, then you'll need to verify the carrier has the PVCs mapped end-to-end correctly in their network. The ATM physical circuit might be fine and dandy but if they have multiple ATM switches this goes through and they have a mis-match in their PVC mappings then it isn't going to work. HTH, Erick --- Bill Smith wrote: > Eric, > > Thank you for your response. It was a typo on my > part entering the > information in the posting. The map-list in the > router does have the > correct IP address. > I have defined (many times) the additional PVC's on > the "NEW SITE" > router/map list without any success. I apologize, I > should have stated > that in my previous posting. > > I inserted the neighbor statements in the OSPF > process, but no success. > THE SHOw IP OSPF Neighbor statement shows > ATTMPT/DROTHER for site "c" > but eventually shows as being down. Also, I > receive a message on the > "new site" router " sent youngest key0".. > > Thank You for your assistance.. > > > -----Original Message----- > From: Erick B. [mailto:[EMAIL PROTECTED]] > Sent: Wednesday, October 09, 2002 7:58 PM > To: Bill Smith; [EMAIL PROTECTED] > Subject: Re: ATM Problem [7:55238] > > Hi, > > The New site has 2 ATM PVCs defined, with a ip entry > mapped to site A and C. Site C has a typo under it's > map-list for the new site, going to 192.58.135.68 > instead of 192.68.135.68. New site has no PVCs for > site B yet configured. > > Also, this is multipoint non-broadcast interface so > under OSPF you will neighbor statements. > > HTH, Erick > > --- Bill Smith wrote: > > Greetings, > > > > I have a problem/question regarding a current ATM > > Circuit. Currently, > > our ATM cloud connects 4 of our sites. We > > submitted an order to add > > another site into the cloud. The telco provided > the > > vpi's but only two > > sites communicate. > > > > > > Site C > > | > > | > > | > > Site A----------- ATM CLOUD ------------Site > B > > | > > | > > | > > NEW Site > > > > Sites a, b, & c communicate correctly. The "NEW > > Site" was added but > > (pvc's to all sites), but will only communicate > with > > Site A. Teloc has > > checked the VPI's and insists they are correct. > > Which brings up another > > strange item--All the VPI's were the same: > > > > New site > > Originating Destination > > 90 90 > > 100 100 > > 80 80 > > > > I have never noticed VPI's being the same on both ends,,Does this > > sound correct? > > > > OSPF is the routing protocol. But only "new site" > > and site a exchange > > info. > > > > Site A > > interface ATM5/0/0 > > ip address 192.68.135.66 255.255.255.240 > > ip pim sparse-mode > > ip ospf authentication-key 7 05180702014D43 > > ip ospf network non-broadcast > > map-group TEST > > atm pvc 1 35 40 aal5snap > > atm pvc 2 36 50 aal5snap > > atm pvc 5 95 95 aal5snap > > atm pvc 6 80 80 aal5snap > > no atm ilmi-keepalive > > > > map-list TEST > > ip 192.68.135.65 atm-vc 1 > > ip 192.68.135.67 atm-vc 2 broadcast > > ip 192.68.135.68 atm-vc 5 broadcast > > ip 192.68.135.68 atm-vc 6 broadcast > > > > > > > > NEW Site > > interface ATM3/0 > > ip address 192.68.135.68 255.255.255.240 > > ip ospf authentication-key 7 05180702014D43 > > ip ospf network non-broadcast > > map-group TEST > > atm pvc 1 95 95 aal5snap > > atm pvc 2 100 100 aal5snap > > no atm ilmi-keepalive > > > > > > map-list TEST > > ip 192.68.135.66 atm-vc 1 broadcast > > ip 192.68.135.65 atm-vc 2 broadcast > > > > > > > > > > Site C > > interface ATM1/0/0 > > ip address 192.68.135.65 255.255.255.240 > > ip ospf authentication-key 7 010007097B0A0B4F > > ip ospf network non-broadcast > > map-group TEST > > atm pvc 1 40 40 aal5snap > > atm pvc 2 100 100 aal5snap > > atm pvc 3 37 60 aal5snap > > no atm ilmi-keepalive > > > > > > map-list TEST > > ip 192.68.135.66 atm-vc 1 > > ip 192.68.135.67 atm-vc 3 > > ip 192.68.135.68 atm-vc 2 broadcast > > > > Any help is greatly appreciated! > [EMAIL PROTECTED] > > > ===== > "Those who are willing to trade freedom for security > deserve neither > freedom nor security." -- Benjamin Franklin > > __________________________________________________ > Do you Yahoo!? > Faith Hill - Exclusive Performances, Videos & More > http://faith.yahoo.com > __________________________________________________ Do you Yahoo!? Faith Hill - Exclusive Performances, Videos & More http://faith.yahoo.com Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=55247&t=55238 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
