On Fri, Oct 11, 2002 at 05:51:00PM +0000, Priscilla Oppenheimer wrote:
[skip]
> The real answer about load was provided by the original poster. Load is for
> output only on a serial link. (I don't think that's true for an Ethernet
> interace?? Anyone know??)
There are RX and TX loads on ether. But this probably depends on IOS version/
interface hardware/whatever... - the box where I checked ether also shows
TX
and RX loads on serial:
Serial0/0 is up, line protocol is up
Hardware is PowerQUICC Serial
MTU 1500 bytes, BW 1024 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 3/255
Encapsulation FRAME-RELAY IETF, loopback not set
Keepalive set (10 sec)
LMI enq sent 178382, LMI stat recvd 178368, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE
Broadcast queue 0/64, broadcasts sent/dropped 4/0, interface broadcasts 4
Last input 00:00:06, output 00:00:02, output hang never
Last clearing of "show interface" counters 2w6d
Input queue: 0/75/5/0 (size/max/drops/flushes); Total output drops: 238
Queueing strategy: weighted fair
Output queue: 0/1000/64/238 (size/max total/threshold/drops)
Conversations 0/27/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 14000 bits/sec, 0 packets/sec
5 minute output rate 2000 bits/sec, 1 packets/sec
37258862 packets input, 3870057433 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
2 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored, 1 abort
42121646 packets output, 1875355617 bytes, 0 underruns
0 output errors, 0 collisions, 4 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
edge#sh ver
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-IO3-M), Version 12.1(6.5), MAINTENANCE
INTERIM SOFTWARE
Best regards,
Dmitry Afanasiev
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=55515&t=55347
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
