I'm confused as to what options and/or target with specific MIB OIDs to capture MSFC VLAN usage with MRTG. My graphs only shows interface EO0/0...which I think is the out of bandwidth interface. Does anyone have a config file that's a good example?
-----Original Message----- From: Elijah Savage III [mailto:[EMAIL PROTECTED]] Sent: Monday, November 25, 2002 9:29 PM To: [EMAIL PROTECTED] Subject: RE: Cat 6500 MSFC1 MRTG [7:58075] Eric here is how you fix it, At the top of your mrtg.cfg file put what I have below, Options[_]:bits,growright -----Original Message----- From: Eric W [mailto:[EMAIL PROTECTED]] Sent: Monday, November 25, 2002 8:54 PM To: [EMAIL PROTECTED] Subject: Cat 6500 MSFC1 MRTG [7:58075] Priscilla, Do you reccomend removing one of the zeros in the config file..I don't understand the fix? Regards, Eric Washington Dear Cisco Fans and professionals, I am monitoring MSFC1 virtual lanv(VLAN) with MRTG, but I find that my graphs reports are a little hard to believe. To my understanding when you creat a config file from MRTG and poll the MSFC it gives the correct bandthwidth for each VLAN, which is (125000000). Can anyone tell me if the above bandwidth is correct for a VLAN interface on Cat6500 MSFC1. Or if I am missing anything? Thanks in advance... Eric _________________________________________________________________ $B:G?7$N%U%!%$%J%s%9>pJs$H%i%$%U%W%i%s$N%"%I%P%$%9(B MSN $B%^%M!<(B http://money.msn.co.jp/ Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=58139&t=58075 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
