Actually, management change the diagram on me :( T1--->3640--->515UR with failover T1--->3640--->^
Both T1s going into a single 515UR with a standby unit. I figured out the first scenario, I just thought of it as it as being in different locations and use global load balancing on the LBs. This second scenario I don't know if it is possible, I would have 2 IPs coming from the e0/0 on the router, into only 1 Pix interface which I don't know if it is possible.... -----Original Message----- From: Brian Zeitz Sent: Friday, December 13, 2002 12:03 PM To: [EMAIL PROTECTED] Subject: Load Balancing Firewalls [7:59183] I have just been given the task of setting up a website with load balancing. T1 ---> 3640-------->Pix 515 UR+4E------>Load balancer T1 ---> 3640------->Pix 515 UR+4E-------->Load balancer The Pix 515 are separate full units, I got another on because I know you cannot use the failover as an active unit. My load balancers are not active/active. But if I use them separately, they can run independently. I need to run just one website like www.mydomain.com My managers would like both T1s to be used, but can also act as a failover. Can anyone give me any pointers or tell me of any pitfalls before I dive into this task? I thought about HSRP, would this work if I had redundant firewalls? Can you cluster pix firwalls? I don't think you can, I wish I could. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=59187&t=59183 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
