mask is not matching in acl to interface. You can also do this, route-map deny_lo1 deny 10 match interface lo1 route-map deny_lo1 permit 20
or else access-list 99 permit host 1.1.1.1 -Keyur Shah- CCIE# 4799 (Security;R/S) CISSP,SCNA,CCSA,MCSE,MCNE "Say Hello to Your Future!" http://www.hellocomputers.com Toll-Free: 1.877.79.HELLO -----Original Message----- From: Cisco Nuts [mailto:[EMAIL PROTECTED]] Sent: Tuesday, January 14, 2003 12:55 PM To: [EMAIL PROTECTED] Subject: route-map deny_lo1 - now working?? [7:61055] Hello, I have a loopback interface 1 that I am trying to deny under redistribute connected under ospf but am having no luck? What am I doing wrong? Please advise. Thank you. Config: TS# interface Loopback1 ip address 1.1.1.1 255.255.255.255 router ospf 100 redistribute connected subnets route-map deny_lo1 route-map deny_lo1 deny 10 match ip address 99 ! route-map deny_lo1 permit 20 match ip address 98 access-list 98 permit any access-list 99 permit 1.1.1.0 On the neighboring router: RTE#r 1.0.0.0/32 is subnetted, 1 subnets O E2 1.1.1.1 [110/20] via 110.99.100.1, 00:05:02, Serial0.100 It does not matter if I change the access-list to permit 1.0.0.0 or host 1.1.1.1 !!! I just cannot seem to figure out why I cannot deny this route from being entered into the routing table!! _________________________________________________________________ Help STOP SPAM: Try the new MSN 8 and get 2 months FREE* http://join.msn.com/?page=features/junkmail Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=61101&t=61055 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
