Make sure the dip switch settings are as follows: 1 UP Data terminal ready normal 2 UP Verbal result codes 3 Down Display result codes 4 UP Echo offline commands 5 UP Auto Answer first ring 6 UP Carrier detect normal 7 UP Load NVRAM defaults 8 Down Smart Mode
You need to reverse telnet into the modem to configure. When you reverse telnet enter the command string. Here is a good link. http://www.cisco.com/warp/customer/471/mod-aux-exec.html Good luck, Scott Terminiello President Scott Enterprises 5 Whitney Drive Marlboro, NJ 07746-1241 Office: (732)972-2698 Email: [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Azhar Teza Sent: Tuesday, February 04, 2003 9:08 PM To: [EMAIL PROTECTED] Subject: Modem Config [7:62479] I am trying to setup a modem dialup for Cisco AUX or Console port. The modem connects fine, but then hangsand never goes to to the router prompt. Is there any special configs for setting up 33.6 usroobotics modem. Here is what I am doing: GLOBAL MODE:modemcap entry usrobotics:MSC=&F1&D3S0=1 LINE MODE:line aux 0 modem InOut modem autoconfigure type usrobotics transport input all speed 38400 flowcontrol hardware line con 0 modem InOut modem autoconfigure type usrobotics transport input all speed 38400 flowcontrol hardware PIN 1, 3 AND 8 DOWN AND THE REST OF THEM UP. Any idea? Thanks, Teza _______________________________________________ Join Excite! - http://www.excite.com The most personalized portal on the Web! Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62480&t=62479 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
