There could be several issues here: 1) Break sequence doesn't work. This may be due to the terminal emulation software that you are using. Some versions of Hyperterminal would not properly send the break signal. One solution is to go to the Hilgraeve site (hope I've spelled that correctly) and download a newer version. If you have another router, see if you can send a break to it. 2) When you say that the router doesn't start - does anything appear on the screen? If so, is it readable? If it is not readable you might try different console speeds. 3) Your IOS upgrade may have failed. Check the Cisco web site for documentation on that. Here's the link to the config register page: http://www.cisco.com/en/US/products/hw/routers/ps285/products_installation_g uide_chapter09186a008007cb01.html
> -----Original Message----- > From: Domingo Ferrero [mailto:[EMAIL PROTECTED]] > Sent: Wednesday, February 05, 2003 8:58 AM > To: [EMAIL PROTECTED] > Subject: Cisco 4000 Series [7:62507] > > > I have a router of the series 4000 of cisco, I have changed > it the IOS but > there I am position in in conf reg a value that is not 0x2101 > neither 0x2102 > and the router does not start, I have tried to enter way > rommon but does not > function any tecla of break. > > Someone it knows like podria to recover the router > > > Thanks and Regards, > > -- > --- > Domingo Ferrero Saavedra [EMAIL PROTECTED] > Dept. Sistemas, IdecNet S.A. > c/ Guzman el Bueno 125 > Madrid-Spain > Tfn: +34 91 824 00 00 > http://www.idecnet.com > --- Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=62513&t=62507 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
