Hello All,
Here is what I have:
Cisco 1721 Router
2 CSU/DSU WICs
1 Ethernet Port to Network
HDLC Connection from Sprint
HDLC Connection from QWEST
Blocks of 32 IP addresses from each provider
Here is what I have so far:
I have both T1 lines running into the router, both of the serial
ports/CSU-DSU appear to be fine and are showing UP. The Problem I am running
into is when I set the ethernet port to a Primary and a Secondary IP
address. I am setting these with numbers from the IP address block that was
given to me from QWEST and Sprint. So in essence I have this:
ip address 65.X.X.X 255.X.X.X QWEST
ip address 65.X.X.X 255.X.X.X Sprint Secondary
ip address 65.X.X.X 255.X.X.X Serial0
ip address 65.X.X.X. 255.X.X.X. Serial1
So my question is this: will this configuration work and if not what do I
need to change: From what I understand I cannot use a subinterface and I
cannot NAT.
Thanks,
Terry O
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=64469&t=64469
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
