Have you set the NIC's to use Switch based load balancing? Have you updated the NIC drivers to the latest?
Cheers, Symon -----Original Message----- From: Azhar Teza [mailto:[EMAIL PROTECTED] Sent: 07 March 2003 23:27 To: [EMAIL PROTECTED] Subject: Etherchannel Problem [7:64791] I have created Etherchannel on Cisco 3524 between port 1-2, 3-4, and 5-6 and they are connected to 3 Dell Servers. Server 1 (Dual Nic) connected to port 1-2 Server 2 (Dual Nic) connected to port 3-4 Server 3 (Dual Nic) connected to port 5-6 The problem is after a few minutes, the 3 servers would lose connection. Another few minutes later, the connection would be good. And another few minutes, the connection is lost. It is basically intermittent. Port 24-25 are also Etherchannel and connected to another cisco switch, and it is working fine. The problem is only b/w servers and the switch. I thought it was the Spanning tree, so I disabled these ports from learning (STP Learning = Disabled), but the results were the same. Any Idea? _______________________________________________ Join Excite! - http://www.excite.com The most personalized portal on the Web! ============================================= This email has been content filtered and subject to spam filtering. If you consider this email is unsolicited please forward the email to [EMAIL PROTECTED] and request that the sender's domain be blocked from sending any further emails. ============================================= Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=64817&t=64791 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
