I have not seen this problem with a 6509 but I have with routers and I RMAed the box.
Dave Donohue, Steve wrote: > Good Morning, > > I was hoping someone could help me out. I have a single SUP module in my > 6509 test chassis. When I power up the chassis with my terminal emulator > connected to the console port I can see the image decompressing, and receive > the message that the module is being tested, with successful results. I > then see my MOTD banner and a request for a password. I also receive > message that both the SUP blade and the MSFC blade are on line. > > Herein lies the problem; the port will not accept any input from my > keyboard. I have moved the console connection to another SUP module in > another chassis and it works like it should. I have altered the baud rate > on my terminal, with no success. I have switch cables for this console, as > well as changing the console port mode (via the button on the front of the > module) with no success. > > Has anyone seen this issue before? Can it be fixed or will I need to setup > an RMA with Cisco? > > Thanks. > > Steve -- David Madland CCIE# 2016 Sr. Network Engineer Qwest Communications 612-664-3367 I would rather have a German division in front of me than a French one behind me." --- General George S. Patton Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=65318&t=65293 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
