Congratulations!
Sebastien Roy wrote: >Folks, > >I can create an IP tunnel that is registered with GLDv3 and mostly >hooked into ip below it. The data-paths are not quite complete, and >there are lots of unfinished corners. > >bash-3.00# dladm create-iptun -T ipv4 -s 10.8.57.39 -d 129.148.174.103 iptun1 >bash-3.00# dladm show-iptun >tunnel name type source destination hoplimit encaplimit >iptun1 ipv4 10.8.57.39 129.148.174.103 0 N/A >bash-3.00# dladm show-link >bge0 type: non-vlan mtu: 1500 device: bge0 >bge1 type: non-vlan mtu: 1500 device: bge1 >aggr1 type: non-vlan mtu: 1500 aggregation: key 1 >iptun1 type: non-vlan mtu: 65515 device: iptun1 >bash-3.00# ifconfig iptun1 plumb 11.0.0.1 12.0.0.2 up >bash-3.00# ifconfig -a4 >lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 >index 1 > inet 127.0.0.1 netmask ff000000 >bge0: flags=1004843<UP,BROADCAST,RUNNING,MULTICAST,DHCP,IPv4> mtu 1500 index 2 > inet 10.8.57.39 netmask ffffff00 broadcast 10.8.57.255 > ether 0:3:ba:29:fc:cc >iptun1: flags=10008d1<UP,POINTOPOINT,RUNNING,NOARP,MULTICAST,IPv4> mtu 65515 >index 4 > inet tunnel src 10.8.57.39 tunnel dst 129.148.174.103 > tunnel hop limit 0 > inet 11.0.0.1 --> 12.0.0.2 netmask ff000000 >bash-3.00# snoop -d iptun1 >Using device /dev/iptun1 (promiscuous mode) > >Since the data-path doesn't quite work yet, I can't demonstrate packets >flowing through here, but that is on the cusp of working as well. > >-Seb > > >_______________________________________________ >clearview-discuss mailing list >clearview-discuss at opensolaris.org >http://mail.opensolaris.org/listinfo/clearview-discuss > >
