Thanks for helping, Ellie, I could work it around,
In /etc/clearwater/config I willingly put wrong IP addresses for
Homestead, and restarted Homestead and Cassandra; then, put the right
values back, and again restarted them. And it did work.
Now I am across another problem; I use Multi-protocol test suite (MTS, a
suite built for IP protocols, including SIP and Diameter; more on it
here: http://mts.arm-tool.com/) and, using it as client, I ask a
REGISTER (that goes fine: REGISTER to Clearwater, that answers 401 with
the credentials of the digest, to which MTS sends another REGISTER;
which is accepted by 200 OK) and, to extend the expiration time, I ask
it again with the digest credentials. But, this time, Clearwater says
403 (request understood, but not processed).
I looked into the logs, and checked again the SIP passwords. I cannot
find where is the problem.
Could you, Ellie, help me on that?
Kindest regards, and good afternoon.
On 10/17/2014 09:43 PM, Eleanor Merry wrote:
Hi,
Thanks for raising this!
There are a couple of possible causes for this.
The first is that the Homestead schema hasn't been properly installed. You can check this by running
"cqlsh -3", then "use homestead_cache;", and finally "describe tables;" - this
should report the impu, impi and impi_mapping tables. If any of these steps fail (for example, because the
homestead_cache keyspace is missing), then you'll need to recreate they keyspace. You can do this most simply
by removing and reinstalling the homestead package.
The second is that there's a potential race condition when homestead-prov
starts up, which can mean it can't connect to Cassandra properly. Can you check
if cassandra is running correctly? You can check this by running 'monit
status', and getting the uptime of the Cassandra process.
If it is still broken, then can you try stopping and starting the services? You
can do this by running the following commands:
monit stop ellis
monit stop homestead-prov
monit stop cassandra
monit start cassandra
(please then wait for cassandra to have fully restarted)
monit start homestead-prov
monit start ellis
Can you let me know if any of the above fixes it? We'll also look at fixing
this properly in the OVF.
Thanks,
Ellie
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Ariel
Otilibili-Anieli
Sent: 10 October 2014 13:10
To: [email protected]
Subject: [Clearwater] Clearwater stays on "Please wait: Loading..."
Hello,
I set up Clearwater on VMware ESXi (running upon Ubuntu 12.04.2 LTS, GNU/Linux
3.5.0-23-generic x86_64) and, as I register a user by the webpage, it keeps on displaying
"Please wait: Loading..."
Also, at the registration, it does not give back the SIP password, contrary to
the manual. Where should I look for? Where may the problem come from?
Thanks a lot in advance.
--
Ariel Otilibili Anieli
55 route de Saint Antoine de Ginestière, 06200 Nice, France
+33 (0)6‒2811‒8730
_______________________________________________
Clearwater mailing list
[email protected]
http://lists.projectclearwater.org/listinfo/clearwater
--
Ariel
_______________________________________________
Clearwater mailing list
[email protected]
http://lists.projectclearwater.org/listinfo/clearwater
