This page is meant specificially for when you're building to a lower
architecture. Ex, your host system is a x86_64 and the target is i686.
$CLFS_TARGET no longer has any effect once you finish chapter 6. The
final system is detected with what the kernel reports through uname &
config.guess.
Sorry for my slow reply, I'm in the process or rebuilding my main
development system.
On Sat, Sep 5, 2009 at 8:12 PM, Roy Bekken <roy.bek...@gmail.com> wrote:
> On Sunday 06 September 2009 00:13:19 Dan McGhee wrote:
>>I have x86_64.
>>
>> <echo ${CLFS_TARGET}> =="x86_64-pc-linux-gnu"
>>
>> from automake-1.11 <lib/config.guess=="x86_64-unknown-linux-gnu"
>>
>> and, finally <uname -m>=="x86_64"
>>
>> Book says, "If the output of that command does not equal what is in
>> ${CLFS_TARGET} then you need to read on." Obviously the output of the
>> command and the value of the variable ALMOST match and 'uname -m' gives
>> 64 bit, but not any of the rest. But is this good enough to proceed?
>
> You should enter the chroot without using setarch. I'm not sure why the native
> book mention that at all, native means that your host is the same as your CLFS
> target.
>
> I would have thought that your CLFS_TARGET would be "x86_64-unknown-linux-gnu"
> but it don't matter that much. The output from config.guess and uname -m is
> not
> literal equal but is the same arch, so you are good to proceed.
> _______________________________________________
> Clfs-support mailing list
> Clfs-support@lists.cross-lfs.org
> http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org
>
_______________________________________________
Clfs-support mailing list
Clfs-support@lists.cross-lfs.org
http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org
