Greetings, I am attempting to build clfs current development (amd64 64-bit). I am at the toolchain section and reached the building of ppl-0.10.2.
The libraries built and installed then it reported an error for a binary. Being unsure if a binary was needed I proceeded with cloog-ppl-0.15.10 only to run into more errors, The error trails are shown below:- ppl-0.10.2 installation test -z "/cross-tools/bin" || /bin/mkdir -p "/cross-tools/bin" /bin/mkdir: cannot create directory `/cross-tools/bin': File exists make[3]: *** [install-binPROGRAMS] Error 1 make[3]: Leaving directory `/mnt/clfs/sources-28810/ppl-0.10.2/src' make[2]: *** [install-am] Error 2 make[2]: Leaving directory `/mnt/clfs/sources-28810/ppl-0.10.2/src' make[1]: *** [install] Error 2 make[1]: Leaving directory `/mnt/clfs/sources-28810/ppl-0.10.2/src' make: *** [install-recursive] Error 1 cloog-ppl-0.15.10 compilation It appears that your system is OK to start CLooG compilation. You need now to type "make". After compilation, you should check CLooG by typing "make check". If no problem occur, you can type "make uninstall" if you are upgrading an old version. Lastly type "make install" to install CLooG on your system (log as root if necessary). ######################################## running make ######################################## make: *** No rule to make target `m4/libtool.m4', needed by `Makefile.in'. Stop. help would be appreciated sincerely bv _______________________________________________ Clfs-support mailing list [email protected] http://lists.cross-lfs.org/listinfo.cgi/clfs-support-cross-lfs.org
