hi, try using the other , the too driver, i had a misdetection when i tryed
first, but then i fixed that, since kernel upgrade , even the detection
problem is gone.. This is how mine works :-)
Bus 0, device 16, function 0:
Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139 (rev 16).
IRQ 10.
Master Capable. Latency=64. Min Gnt=32.Max Lat=64.
I/O at 0xe400 [0xe4ff].
Non-prefetchable 32 bit memory at 0xef000000 [0xef0000ff].
hope that one helped
Szemir
On Thursday 05 September 2002 21:52, you wrote:
> try
> #cat /proc/pci
> see if your card is there
>
> (would look like similar to...)
> Bus 0, device 8, function 0:
> Ethernet controller: D-Link System Inc RTL8139 Ethernet (rev 16).
> IRQ 12.
> Master Capable. Latency=32. Min Gnt=32.Max Lat=64.
> I/O at 0x6000 [0x60ff].
> Non-prefetchable 32 bit memory at 0xf0000000 [0xf00000ff].
> Bus 0, device 9, function 0:
> Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C
> (rev 16). IRQ 11.
> Master Capable. Latency=32. Min Gnt=32.Max Lat=64.
> I/O at 0x6100 [0x61ff].
> Non-prefetchable 32 bit memory at 0xf0001000 [0xf00010ff].
>
>
> type dmesg, if you don't see your card there... its not setup :(
>
> #man dmesg
> for more info.
>
> I have for example, after typing dmesg I notice: (built into the kernel, in
> this case)
>
> eth0: D-Link DFE-538TX (RealTek RTL8139) at 0xc3002000, <MAC addy removed>,
> IRQ 12 eth0: Identified 8139 chip type 'RTL-8139C'
> eth1: RealTek RTL8139 Fast Ethernet at 0xc3004000, <MAC addy removed>, IRQ
> 11 eth1: Identified 8139 chip type 'RTL-8139A'
>
> Using locate, I noticed I have eth0 and eth1 located:
> /proc/sys/net/ipv4/conf
>
> if you have it setup as a module, edit your /etc/modules.conf
> file and add the following line
>
> alias eth0 8139too
>
> I Hope this helped.
>
> Richard.
> icq: 20627344
>
> On Thu, 05 Sep 2002 21:12:47 -0600
>
> HJ Hornbeck <[EMAIL PROTECTED]> wrote:
> > > The default driver that comes with the
> > > kernel (8139too.c) compiles fine and at boot of the new kernel has no
> > > problem initializing the ethernet card. However, once I'm booted up and
> > > logged in, I cannot communicate with anything. It's like the network
> > > cable is unplugged.
> >
> > What sort of RealTek card is it? The RedHat 7.3 kernel includes two
> > drivers, one for the C+ variant.
> >
> > Are you sure the network card works at all? From your description, no
> > data is actually getting out across the wire. If the machine isn't set up
> > to dual boot, try a floppy- or cd-based minidistro of Linux.
> >
> > HJ Hornbeck
